Difference between revisions of "Welder Requalification eForm"

From ProStar Geocorp
 
Line 1: Line 1:
 
= '''Overview''' =
 
  
 
This section covers the Welder Requalification eForm in PointMan. ''Note: This eForm is not available in PointMan local by default, but can be added if needed for your workflow''
 
This section covers the Welder Requalification eForm in PointMan. ''Note: This eForm is not available in PointMan local by default, but can be added if needed for your workflow''

Latest revision as of 08:40, 20 September 2018

This section covers the Welder Requalification eForm in PointMan. Note: This eForm is not available in PointMan local by default, but can be added if needed for your workflow



Procedure

  1. On the map, click the New button in the upper right corner.
  2. From the System drop-down, select: Form
  3. From the Component drop-down, select: Document
  4. Click OK.
  5. Select Welder Requalification, and then click OK
    The Welder Requalification eForm displays 3 separate pages. 

    Page 1: 
    PointMan WRQ 1.png

    Page 2: 
    PointMan WRQ 2.png

    Page 3: 
    PointMan WRQ 3.png
     
  6. Enter all applicable information.
  7. When complete, click Close (upper right corner), then Save (lower right corner).