Welder Qualification eForm

From ProStar Geocorp
Revision as of 08:37, 20 September 2018 by WJessop (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

This section covers the Welder Qualification eForm in PointMan. Note: This eForm is not available in PointMan local by default, but can be added if needed for your workflow


  1. On the map, click the New button in the upper right corner.
  2. From the System drop-down, select: Form
  3. From the Component drop-down, select: Document
  4. Click OK.
  5. Select Welder Qualification, and then click OK
    The Welder Qualification eForm displays 3 separate pages.

    Page 1: 
    PointMan WQ 1.png

    Page 2: 
    PointMan WQ 2.png

    Page 3: 
    PointMan WQ 3.png
  6. Enter all applicable information.
  7. When complete, click Close (upper right corner), then Save (lower right corner).