Operation Maintenance Section C
From ProStar Geocorp
Revision as of 08:48, 18 September 2018 by WJessop
This page details how to fill out section C of the Operation Maintenance form.
- Select the applicable forms from the Pipeline Task list
- Complete Section A
- Select the C tab at the top of the dialog box.
The CP Protection Installation/Repair - Section C dialog displays.
Use the right-side scroll bar to view and access all of the fields and check boxes.
- Complete the C tab by completing each field as required or necessary:
|Install or Repair||Select either Install or Repair radio button.|
|Anode||Select this check box if installing or repairing anodes.|
|Anode Type||Select value from the drop-down list.|
|No of Anodes||Enter the number of Anodes.|
|Anode Backfill Material||Enter the Anode Backfill Material.|
|Anode Spacing||Enter the Anode Spacing in Ft. and In.|
|Anode Depth||Enter the Depth of the Anode in Ft. and In.|
|Ground Bed||Select this check box if working in ground beds.|
|Test Lead||Select this check box of working on test leads.|
|Coupon Test Station||Select this check box if involving coupon test station.|
|Bond||Select this check box if performing a bond.|
|If Bond Selected||Select a value from the drop-down list.|
|Method of Attachment||Select a value from the drop-down list.|
|Coating Applied||Select a value from the drop-down list. If you select Other from the list, enter the Other value in the field below.|
|Other||If you selected Other from the drop-down list above, enter the value here.|