Operation Maintenance Section B

From ProStar Geocorp

This section details how to fill out section B of the Operation Maintenance form.

 

Pre-requisites: 

  1. Select the applicable forms from the Pipeline Task list. 
  2. Complete Section A.
  3. Select the B tab at the top of the dialog box. 
    The Visual Pipe Inspection - Section B dialog displays. 
    Use the right-side scroll bar to view and access all of the fields and check boxes. 
    RTENOTITLE
    RTENOTITLE
    RTENOTITLE
    RTENOTITLE
    RTENOTITLE
    RTENOTITLE
  4. Complete the B tab by completing each field as required or necessary:

Section B Fields

Field Action
Exposures and External Pipe Inspection  
Was Pipe Exposed Prior to Work Being Performed? Select either Yes or No radio button.
Length of Exposer Enter the length of the exposure in Ft and In.
Pipe Span?   Is there space between the bottom of the pipe and the ground? Select either Yes or No radio button.
If Span  
Unsupported Span? Select either Yes or No radio button.
Span Length Enter the Span Length in Ft and In.
Distance Between Pipe Supports Enter the Distance between pipe supports in Ft and In.
Soil Type  
Exposure Reason   Select a value from the drop-down list. If you select Other, enter the Other value in the field below
Other   If you selected Other from the drop-down list, enter the Other value here.
Existing Coating Type Select from the drop-down list.
Line Depth (Inches) Enter the line depth.
Coating Select the Bonded or Disbonded radio button.
 % Disbonded If Disbonded, enter the % disbonded.
Pipe to Soil Enter the Pipe to Soil value in mV.
Soil Resistivity Enter the Soil Resistivity in ohm-cm.
Soil PH Enter the Soil PH
Present Wall Thickness (Inches) Enter the Wall Thickness at the 9, 12, 3 and 6 locations.
Damage to Pipe   Select the type of Damage to the pipe from the drop-down list. If you select Other, enter the Other value in the field below.
Other If you selected Other from the drop-down list, enter the Other value here.
Pipe Corrosion Select a value from the drop-down list.
Feature/Anomaly Measurements  
Circumferential Width Enter a value in inches.
Longitudinal Length Enter a value in inches.
Max Depth Enter a value in inches.
Remaining WT Enter a value in inches.
O'Clock Position Enter the applicable O'clock Position
Direction of Flow Enter the direction of flow.
Pipe Cased? Select either Yes or No radio buttons.
Casing Description Select a value from the drop-down list. If you select Other, enter the Other value in the field below.
Other If you selected Other from the drop-down list above, enter the Other value here.
Internal Pipe Inspection  
Pipe cut to perform internal inspection? Select either Yes or No radio buttons.
Pipe Corrosion: Select a value from the drop-down list.
Circumferential Width Enter a value in inches.
Longitudinal Length Enter a value in inches.
Max Depth Enter a value in inches.
Remaining WT Enter a value in inches.
O'clock Position of Corrosion Enter the applicable O'clock position.
Direction of Flow Enter the direction of flow.
Comments Enter all additional comments as necessary.