Laying Out As-Built Lines

From ProStar Geocorp
Revision as of 11:45, 15 September 2020 by BenS (Talk | contribs) (Created page with " == '''Procedure''' == 1. Login to PointMan 2. Tap the Menu 3. Tap Settings 4. Scroll down to the Map section 5. In the list of checkboxes, make sure that the "As-Built"...")

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Procedure

1. Login to PointMan

2. Tap the Menu

3. Tap Settings

4. Scroll down to the Map section

5. In the list of checkboxes, make sure that the "As-Built" option is checked (turned on)

6. If applicable, pair a GPS unti in the same settings page

7. Tap Close on the top right corner

8. Every time you collect a new line or edit an existing line, the As-Built popup will ask you to select the Quality Level, Method, and Antenna Height

9. Once the data is collected or updated, tap details (points), or pedigree (lines) to view the As-Built settings. IMPORTANT: Verify this against the Horizontal and Vertical Accuracy to make sure the data is accurate enough to match the Quality Level.